Can someone tell me where I plug a Dynojet push quick shifter into a Yoshi loom on a GSXR600 K7?
I was told it would just plug into the side stand connector but I can't find any plug that fits.
Thanks,
Simon
Yoshi Loom GSXR600 K7 Dynojet QS
- Simon Smith
- Throttle on the Stop
- Posts: 592
- Joined: Tue Jan 15, 2008 9:16 pm
- D/P/T/M/S: Driver
- Full Name: Simon Smith
- Twitter: @simonsmithno92
- Location: Solihull, West Midlands
- Contact:
Yoshi Loom GSXR600 K7 Dynojet QS
No 92
F2 Sidecar Race Team
http://WWW.FPARACING.CO.UK
http://WWW.CALEBSMITHRACING.CO.UK
F2 Sidecar Race Team
http://WWW.FPARACING.CO.UK
http://WWW.CALEBSMITHRACING.CO.UK
-
- On the Starting Grid
- Posts: 18
- Joined: Mon Feb 08, 2010 9:38 am
- D/P/T/M/S: Driver
- Full Name: Mick Alton
- Location: Sydney Australia
Re: Yoshi Loom GSXR600 K7 Dynojet QS
Hi, it the Black/white and blue connector located just below the main throttle body connector, Cheers Mick
- Simon Smith
- Throttle on the Stop
- Posts: 592
- Joined: Tue Jan 15, 2008 9:16 pm
- D/P/T/M/S: Driver
- Full Name: Simon Smith
- Twitter: @simonsmithno92
- Location: Solihull, West Midlands
- Contact:
Re: Yoshi Loom GSXR600 K7 Dynojet QS
Thanks, it's been cut off my loom. So is the blue wire with brown dots the same one that goes into the black ecu plug? If I wire the qs with one wire going to earth and the other going to the cut blue with brown dots wire that goes into the black ecu plug, will that work?
No 92
F2 Sidecar Race Team
http://WWW.FPARACING.CO.UK
http://WWW.CALEBSMITHRACING.CO.UK
F2 Sidecar Race Team
http://WWW.FPARACING.CO.UK
http://WWW.CALEBSMITHRACING.CO.UK
-
- On the Starting Grid
- Posts: 18
- Joined: Mon Feb 08, 2010 9:38 am
- D/P/T/M/S: Driver
- Full Name: Mick Alton
- Location: Sydney Australia
Re: Yoshi Loom GSXR600 K7 Dynojet QS
I have chased mine back and it has continuity (3rd terminal in from the orange wire next to the black/ white), but why not pick them up from where they have been cut off?