Page 1 of 1
Yoshi EMPro Quickshifter pins
Posted: Tue Apr 08, 2014 8:36 pm
by Simon Smith
I've got a Yoshi EmPro on my GSXR600 K7. I'd like to fit a compatible quick shifter that doesn't result in the fault code light displaying.
I know the EmPro uses the side stand switch to activate the ignition kill. Can anybody tell me the plug pin numbers for the side stand switch? I think mine may have been cut off.
Re: Yoshi EMPro Quickshifter pins
Posted: Tue Apr 08, 2014 9:52 pm
by Eurocup
hi
it is the green plug.
just plug in and it works....on mine it did.
bye Eckart
Re: Yoshi EMPro Quickshifter pins
Posted: Tue Apr 08, 2014 10:10 pm
by Simon Smith
I don't have a green plug.
Re: Yoshi EMPro Quickshifter pins
Posted: Sat May 31, 2014 5:31 pm
by uw.engineer
Hi,
If you have a Yoshi race loom, there should be a green plug (same as side stand plug) which is wired for the quickshifter.
Remember to set it up in the software.
On the ECU Yoshi for a 1000cc on a normal harness it is pin 51 or 52 (blue/black) (blue/white) one was for the quick shift the other was pit speed limiter
Re: Yoshi EMPro Quickshifter pins
Posted: Sat May 31, 2014 5:53 pm
by uw.engineer
Hi,
Just found this, not 100% about where it came from.
It shows blue/green pin 15 on the black connector.
Re: Yoshi EMPro Quickshifter pins
Posted: Mon Jun 02, 2014 11:04 pm
by Simon Smith
That's great. Thank you. I do have a Yoshi but the previous owner has removed some of the plugs and wires. That's why I needed to know the plug numbers.