The Place

What's the best/best value quickshifter for a Suzuki 600 K7 (Yoshi electrics)?

Any advice welcome.

Translogic mate they do a plug and play easy to wire and fit and no setting up because they use a switch with 3 different delay settings and are reasonably priced look on there website they fit directly into the coils so it doesnt matter what electrics you are running

Thanks Craig.

If you use Translogic wire in an on-off switch for when it packs in in the wet.
If I hadn't done this we would have been watching from the side of the track instead of winning the Dongo trophy.

You did well mate from where I was watching until we aquaplaned past hairpin And lost position:D note to self cut tyres deeper

teamradar wrote:If you use Translogic wire in an on-off switch for when it packs in in the wet.
If I hadn't done this we would have been watching from the side of the track instead of winning the Dongo trophy.

Weve used Translogic for a few years now Andy. It only packed in once , Phil just changed gear as if there wasnt a quick shifter fitted. Or am I missing someting.

oldbelly wrote:

teamradar wrote:If you use Translogic wire in an on-off switch for when it packs in in the wet.
If I hadn't done this we would have been watching from the side of the track instead of winning the Dongo trophy.

Weve used Translogic for a few years now Andy. It only packed in once , Phil just changed gear as if there wasnt a quick shifter fitted. Or am I missing someting.

[/quote]
Weve used Translogic for a few years now Andy. It only packed in once , Phil just changed gear as if there wasnt a quick shifter fitted. Or am I missing someting.[/quote]

It cut the ignition and it stayed cut until I turned it off then it fired up again.

That sounds more like the sensor in the gear lever faulty andy if u need to switch it off