As the topic subject indicates, I can't figure out what is holding the bearing hub to the wheel. I prefer not to destroy the hub by using a press. I've stuck a piece of welding wire into the bolt holes and it protrudes into the Windle hub so there doesn't appear to be any kind of mechanical fasteners used. The bearings need to be replaced so any help would be greatly appreciated.
Hank Nelson, San Jose, CA
How do you get this bearing retainer off a Windle wheel
-
tekguyonroad
- On the Starting Grid
- Posts: 15
- Joined: Sat Feb 22, 2014 1:56 am
- D/P/T/M/S: D
- Full Name: Henry Nelson
-
gatekeeper
- Setting the Fastest Lap
- Posts: 233
- Joined: Tue Jul 31, 2007 6:51 am
- D/P/T/M/S: dodgy driver
- Full Name: ian[gatey]derbyshire
- Location: sunny heanor but its raining
Re: How do you get this bearing retainer off a Windle wheel
it is part of the casting use a hot gun or similar to heat the hub up they come out easy
just one more lap and i'll have him